Residential
wall-mount-spinning-flagpole
Wall-Mount Spinning Flagpole — 6 Foot
Residential
FPA009NF
The wall-mount spinning pole is the right answer for any home that wants a properly displayed flag without a foundation project. It screws to a porch post, a garage wall, a deck railing, or any solid exterior surface with the included bracket — and once it is up, it looks like it belongs there.
No digging required
Installs in 20 minutes
Spinning — no flag wrap
Bracket and hardware included
6'
Pole length
1"
Diameter
20
Min install
27x54
Recommended flag
The wall-mount spinning pole is the right answer for any home that wants a properly displayed flag without a foundation project. It screws to a porch post, a garage wall, a deck railing, or any solid exterior surface with the included bracket — and once it is up, it looks like it belongs there.
The spinning mechanism is the feature that makes this pole worth having over a fixed-mount alternative. The pole rotates freely in the bracket, which means the flag follows the wind instead of wrapping around the shaft. On a fixed pole, a flag that wraps is a flag that tears. The spinning design eliminates that entirely.
The 6-foot white aluminum shaft is the standard residential length — proportional to a single storey home or cottage, sized for a 27x54 or 36x72 flag. It comes as the pole only, or paired with a 27x54 Canadian flag if you want everything in one order.
Ideal for:
Homeowners, cottage owners, renters with exterior wall access, and anyone who wants a clean residential flag display without installing a ground sleeve.
Foundation Requirements
Foundation Diameter:
N/A
Foundation Depth:
N/A
Concrete Spec:
Anchor Bolts:
N/A
Included mounting screws
The minimum depth assumes compacted soil. The Building Code typically requires footings below the frost line — generally a minimum of 4 feet (48") below finished grade. Consult your local municipality if in doubt. The anchor cage shipped with the pole is designed for a 4'–6' minimum depth.
Installation Overview
Engineering drawings and full installation instructions ship with the pole. This is a summary for planning purposes.
01
Dig and Pour
Auger or excavate a 26" diameter hole to 44" minimum depth. Bed in gravel, set anchor cage, pour 3,000 PSI concrete. Allow 7 days full cure (or 1 day with quick-set).
03
Walk the pole up
Assemble pole horizontal. Attach hinge pin to base. Two or three people walk the pole up to vertical from the hinge side. Secure the two non-hinge bolts.
02
Level the base
Once cured, thread leveling nuts onto anchor bolts. Place the hinge base plate over the cage, shim level in both directions, and secure with washers and large nuts.
04
Rig and Install
Verify halyard through cam cleat, attach counterweight and snaps, thread the ball finial, install flash collar. Apply silicone bead at collar top. Raise your flag.