Indoor
indoor-floor-stand-flagpole
Indoor Floor Stand Flagpole
Indoor
FLRSTAND01
Floor stands are the simpler indoor option — a weighted base, a staff, and a clip, without the ornamental hardware of a full Confederation presentation set. They are the right choice for a lobby, a real estate office, a showroom, or any space that needs a clean flag display without the formal weight of a ceremonial setup.
Self-supporting weighted base
Staff and clip included
No wall support needed
Indoor
Use type
7-8'
Display height
3x5
Recommended flag
None
Installation needed
Floor stands are the simpler indoor option — a weighted base, a staff, and a clip, without the ornamental hardware of a full Confederation presentation set. They are the right choice for a lobby, a real estate office, a showroom, or any space that needs a clean flag display without the formal weight of a ceremonial setup.
The base is weighted to stand without wall support. Staff lengths vary to suit ceiling heights and flag sizes — the standard kit is sized for a 3x5 or 4x6 flag on a 7 to 8-foot staff. The simple clip attachment works with any standard grommet flag.
These pair naturally with a Canadian flag or provincial flag set. For a more formal installation, the Confederation base presentation sets are the step up — same concept, heavier hardware, and gold finial included.
Ideal for:
Office lobbies, real estate offices, car dealership showrooms, retail locations, hotel entrances, and any commercial indoor space that needs a clean, self-supporting flag display.
Foundation Requirements
Foundation Diameter:
N/A
Foundation Depth:
N/A
Concrete Spec:
Anchor Bolts:
N/A
N/A
The minimum depth assumes compacted soil. The Building Code typically requires footings below the frost line — generally a minimum of 4 feet (48") below finished grade. Consult your local municipality if in doubt. The anchor cage shipped with the pole is designed for a 4'–6' minimum depth.
Installation Overview
Engineering drawings and full installation instructions ship with the pole. This is a summary for planning purposes.
01
Dig and Pour
Auger or excavate a 26" diameter hole to 44" minimum depth. Bed in gravel, set anchor cage, pour 3,000 PSI concrete. Allow 7 days full cure (or 1 day with quick-set).
03
Walk the pole up
Assemble pole horizontal. Attach hinge pin to base. Two or three people walk the pole up to vertical from the hinge side. Secure the two non-hinge bolts.
02
Level the base
Once cured, thread leveling nuts onto anchor bolts. Place the hinge base plate over the cage, shim level in both directions, and secure with washers and large nuts.
04
Rig and Install
Verify halyard through cam cleat, attach counterweight and snaps, thread the ball finial, install flash collar. Apply silicone bead at collar top. Raise your flag.